Escient FireBall H-40 Remote control Manuel d'utilisateur télécharger pdf (Page 110)

110

TheaterTouch Designer

CAPTURING IR CODES WITH AN IR-PRO LEARNING DEVICE

The first step in capturing IR codes with an IR-PRO learning device is to align the donor remote correctly. This

step is very important, as it allows the Infrared Library Manager to determine the carrier frequency of the donor

remote.

1. Connect the IR-PRO to a free USB port on your PC.

2. Select the Capture tab.

3. Choose the Enable Capture button.

4. Choose the Align button.

5. When the device is in Align mode, you will see the

following on the Capture tab:

6. Hold down any key on the donor remote, and move

it around in front of the capture unit until the signal

strength meter turns red and the frequency reading

is stable.

Once the remote is properly aligned:

1. Select the "Learn" button. The Infrared Library

Manager will automatically highlight the first func

tion in the current library without an associated IR

code.

2. If you want to learn another function, select it in the

function list. Your Capture tab should now look like

this:

3. Press and hold down the requested function ("Play"

in this case) until the Infrared Library Manager

learns the code and moves on to the next code.

Important: Once you have the donor remote aligned, try to avoid moving it while capturing codes. If the remote

does move out of position, select the Align button and go through the alignment procedure again. If you are having

problems communicating with your USB device, see Troubleshooting Communications Problems - Chapter 12.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 144 145

Pas de commentaire

Escient FireBall H-40 Remote control Manuel d'utilisateur Page 110